30Linux base and applications installation and upgrade task flow
Step Action
There are no prerequisites for this procedure.
1Open a command line interface session to the Primary ECM Security Server through the serial port with the nortel account.
2Switch user to the root account by typing SU and press <enter>.
3Enter the root user password when prompted.
4Execute the following script:
/opt/nortel/isclient/setup_ssha.sh deconfig
5If a Backup ECM Security server is present in the system, switch user to the root account and execute the script
/opt/nortel/isclient/failOver.sh <FQDN of Primary ECM Security Server>
where <FQDN of Primary ECM Security Server> is set to the FQDN of the Primary ECM Security server.
6Wait for two minutes after the command completes before proceeding.
7Switch user back to the nortel account by typing exit.
8Perform the “Upgrading Nortel Linux base ” (page 54) procedure.
9Open a command line interface session to the Primary ECM Security Server through the serial port with the nortel account.
10Install the following patches onto the Primary ECM Security server using the “Patching Operation” (page 106) procedure.
•MPLR25520
•MPLR25521
This procedure describes upgrading the Primary ECM Security server from Rls 5.00 to Rls 5.50 in a configuration with a Backup ECM server and three or more Member servers associated with it.
1c: Upgrade Primary server with Backup server and three or more Member servers
Step Action
There are no prerequisites for this procedure.
1Open a command line interface session to the Primary ECM Security Server through the serial port with the nortel account.
2Switch user to the root account by typing SU and press <enter>.
Nortel Communication Server 1000
Linux Platform Base and Applications Installation and Commissioning
29 October 2008