Nortel Networks 3500, NTRN10AN manual Client Service Mismatch

Operation, administration, and maintenance (OAM) features 2-83

Table 2-12 (continued)

Egress WAN port and service alarms

Alarm	Description	Severity
Client Service Mismatch	This alarm is raised against the LAN port	Critical, service affecting (C, SA)
	of a 2xGigE/FC-P2P circuit pack when
	one of the following conditions occurs:
	• the client service provisioned on the
	remote 2xGigE/FC-P2P circuit pack
	does not match the client service
	provisioned on the local
	2xGigE/FC-P2P circuit pack.
	• the Sub-rate and Extended reach
	parameters for a Fibre Channel facility
	are not provisioned to the same setting.
Far End Client Rx Signal Fail	This alarm is raised against a	Critical, service affecting (C, SA)
	2xGigE/FC-P2P circuit pack when a
	problem occurs at the far-end
	2xGigE/FC-P2P circuit pack that
	terminates the service.

Note: Refer to Gigabit Ethernet Drop and Continue feature description for more details on this alarm. If the alarm is raised against the WAN port of 2xGigE/FC interface and no other WAN and/or SONET related alarms are active, the following must be performed to clear the alarm:

— Delete all cross-connections to the WAN port

— Delete the Ethernet facility (DLT-ETH)

— Add the Ethernet facility (ENT-ETH)

— Re-enter the unidirectional cross-connection(s)

Refer to Bandwidth Management, 323-1059-320,Equipment and Facility Provisioning, 323-1059-350 and Alarm and Trouble Clearing, 323-1059-543.

Planning and Ordering Guide—Part 1 of 2 NTRN10AN Rel 12.1 Standard Iss 1 Apr 2004