Press the <AUDIO> button to display the [AUD01:LEVEL] screen of SmartUI.

Chapter 10 Maintenance and Inspection — Inspections before shooting

4 Turn the microphone connected to the <MIC IN> terminal to an appropriate audio source, and ensure that both level displays for CH1/CH2 change according to the audio volume.

Inspecting the audio level manual adjustment1Press the <AUDIO> button to display the [AUD02:INPUT] screen of SmartUI.

2 Set the [IN] item in CH1/CH2 to [FRONT].

3Set the [LVL] item in CH1/CH2 to [MANU].

4

5

6

Turn the microphone connected to the <MIC IN> terminal to an appropriate audio source, and adjust the audio volume settings for CH1/CH2.

Select the [+] item of CH1/CH2 to ensure that the level displays increase.
Inspecting the earphone and speaker1Adjust the <MONITOR> dial and ensure that the speaker volume changes.
2 Connect an earphone to the <PHONES> terminal.

Ensure that the speaker is muted and the output from the microphone is directed to the earphone.

3 Adjust the <MONITOR> dial and ensure that the earphone volume changes.Inspections for using an external microphone

1Connect the external microphone to the <AUDIO IN CH1/3> and <AUDIO IN CH2/4> terminals and push the <LINE>/<MIC> selector switch towards the <MIC> side.

2 Toggle the microphone input <+48V> ON/OFF switch according to the power supply for the external microphone.

<+48V>

For microphones with an external

 

power supply

<OFF>

For microphones with an internal

 

power supply

3Press the <AUDIO> button to display the [AUD02:INPUT] screen of SmartUI.4 Set the [IN] item in CH1/CH2 to [REAR].

5Turn the microphone to an audio source, and confirm that the audio level display on the viewfinder screen or on SmartUI changes according to the audio volume.

You can check each channel by connecting one microphone to each channel.

Inspections for the clock, time code, and user bits1Set the user bits as needed.

For details, refer to “User bits settings” (page 66).

2 Set the time code.

For details, refer to “Setting the time code” (page 68).

3Press the <HOME> button to display the [HOME] screen of SmartUI.4 Press the <COUNTER> button to display [TC].5Press the <SETUP> button to display the [SET01:TC/UB] screen of SmartUI.6Set the [TC_MD] item to [R‑RUN].7Press the <HOME> button to display the [HOME] screen of SmartUI.8Press the <REC> button.

Ensure that the number in the counter display changes when the recording starts.

9Press the <REC> button again.

Ensure that the number in the counter display stops changing when the recording stops.

10 Press the <SETUP> button to display the [SET01:TC/UB] screen of SmartUI.11 Set the [TC_MD] item to [F‑RUN].
12 Press the <HOME> button to display the [HOME] screen of SmartUI.

Ensure that the number in the counter display changes regardless of the recording status.

13 Push the <DISP/MODE CHK> switch towards the <CHK> side and check the date and time displayed on the viewfinder screen.

If [DATE], [TIME], or the time zone is incorrect, set the correct date/ time (page 31).

@@NOTE

ttNote that date and time data based on [DATE], [TIME], or the time-zone setting is recorded in the clip and affects the playback order in the thumbnail operations.

– 155 –