Panasonic AG-HPX600EJ, AG-HPX600EN, AG-HPX600P Safety zone display, Center marker display, Zebra patterns display, Item, [RTP], [OFF], [90%], [4:3], [HTTP], [13:9], [14:9], [ERROR], [INHIBIT], [!PRE REC]

Chapter 4 Adjustments and Settings for Recording — Viewfinder status display

		Display item		Display details
NETWORK	5		[NETWORK]	Network type and operation status
				[WLAN], [LAN], [OFF]
				ffIf the selected network is not operated, [ERROR] is displayed at the bottom.
	6*		[STREAM]	Streaming mode and status display
				ff[RTP]: When RTP mode is selected
				ff[HTTP]: When HTTP mode is selected
				ff[ERROR]: Streaming cannot be activated
				ff[INHIBIT]: When the [STREAMING MODE] item of the menu is set to [INHIBIT]
	7*		[ERROR] factor of [STREAM]	Display the factor why streaming is not activated
				ff[!PROXY MODE]: When proxy setting is not streaming-compatible format
				ff[!PRE REC]: When pre-recording function is turned on and proxy recording is set

* This is not displayed if the network function is not activated, or if the video encoder board (optional AG‑YDX600G) is not installed.

Center marker displayThe [MARKER] item on the setting menu [DISPLAY SETUP] screen is set to [ON].

@@NOTE

ttThe center marker is displayed only in the viewfinder. It is not displayed in the video output and SDI output.

Safety zone display

The option selected at the [SAFETY ZONE] item on the setting menu [DISPLAY SETUP] screen is displayed.

[OFF]	Does not display.
[90%]	Displays the range that can be displayed in most household TVs.

[4:3] Displays the position after the screen is adjusted by 4:3 aspect ratio.

[13:9] Displays the position after the screen is adjusted by 13:9 aspect ratio.

[14:9] Displays the position after the screen is adjusted by 14:9 aspect ratio.

@@NOTE

ttWhen the [SYSTEM MODE] item on the [SYSTEM SETUP] screen is set to [480‑59.94i] and [576‑50i], and the [ASPECT CONV] item is set to [SIDE CROP] and [LETTER BOX], this is not displayed even by selecting [4:3], [13:9], or [14:9].

ttThe center zone is displayed only in the viewfinder. It is not displayed in the video output and SDI output.

Zebra patterns displayThe camera can display two types of zebra patterns.

When the ZEBRA switch of the viewfinder is set to on, the zebra pattern currently set in the menu is displayed on the viewfinder screen. Zebra patterns can also be displayed in the video of the <MON OUT> terminal according to settings.

The level for displaying zebra patterns can be set on the setting menu [DISPLAY SETUP] screen.

Item	Setting value			Description of settings
[ZEBRA1 DETECT]	[50%] ...	[70%] ...	[109%]	Sets the level of zebra pattern 1 tilting to the right.
[ZEBRA2 DETECT]	[50%] ...	[85%] ...	[109%]	Sets the level of zebra pattern 2 tilting to the left.
[ZEBRA2]	[ON], [SPOT], [OFF]			Selects the type of [ZEBRA2].

Underlined settings are factory settings.

– 81 –