Panasonic AW-F575E manual Electronic Viewfinder WV-VF65B, Lens Control KIT WV-LK35

5” ELECTRONIC VIEWFINDER WV-VF65B

211. Tally Light

215. Peaking On/Off Switch (PEAKING ON/OFF)

LENS CONTROL KIT WV-LK35

This light only works when the camera is “sed in full system operation with the Remote Control Unit (RCU) and Special Effects Generator This light Indicates that recording is in progress

212. Contrast Control (CONTRAST)

Turn this control clockwise to increase the contrast of the picture in the viewfinder

213. Brightness Control (BRIGHT)

Turn this control clockwise to increase the brightness of the picture in the viewfinder

214. Tally ON/OFF Switch (TALLY ON/OFF)

This switch turns on/off the Tally Light (211) located on front of the viewfinder

Normally this switch should be set to the OFF position

However, when shooting under low light conditions,

setting this switch to the ON position will facilitate easi-

er focusing adjustment

216. Viewfinder Adjustment Knob

The angle of the 5" viewfinder can be adjusted for easy and comfortable viewing

217.Tally Indicator

When used in full system operation with the Remote Control Unit (RCU) and Speclal Effects Generator. this indicator shows the camera operator that recording is in progress and the recording signal is being sent to the line output.

218.5” Viewfinder Mounting Bracket WV-071

This is used to mount the 5" Electronlc Viewfinder WV- VF65B, on the AW-F575E Colour Camera

See page 34 for installation details

221. Clamper

Install the zoom controller on the right tripod arm by using this clamper.

222. Servo Zoom Control

The 1.4f zoom lens can be controlled by pressing this Control to zoom in/out for tele/wide picture with motor drive. The zoom speed can be adjusted by changing the pressure on this control

223. Return Video Button

In a studio application using a special effects genera- tor, the lineview signal is displayed on the viewfinder while this button is being pressed. When a Panasonic

3/4" U-vision portable VTR with a 14-pin camera in/out connector or an S-VHS VTR is in the playback mode, the playback picture is seen by pressing this button

224. VTR Start/Stop Button

This button is used to start or pause the VTR Press this button for recording and press it again for pause.

225. Clamper

Install the focus controller on the left tripod arm by using this clamper

226. Focus Controller

Turn this controller for adjusting the lens focus

inout

- 29 -