Panasonic AW-HS50N System settings, System menu settings, Setting the video format

6. System settings

6-1. System menu settings

6-1-1. Setting the video format

The video format of the entire system to which the unit is connected can be set.

=?5;56'//GPW

(QTOCV K

*K4GU/8 1HH

53 1HH

#7:#PEK 1HH

2)/#PEK 1HH

289#PEK 1HH

/8#PEK 1HH

+PKVKCN 1HH

+2#FFTGUU 

5WDPGV/CUM 

)CVGYC[  /#%#FFTGUU

Note

The [14] SYSTEM Menu settings cannot be changed if “Locked” has been set using the menu item below.

[13]Operation Menu

14.SYSTEM Menu

[14]SYSTEM Menu

1.Format

Select the supported format from among the options provided below.

Supported formats

1080/59.94i	1080/50i
720/59.94p	720/50p
1080/24psf	1080/23.98psf
480/59.94i	576/50i

<How to specify the video format and then start the system>

With the unit in the power-off status, the video format can be specified and the system started.

Set the POWER switch to ON while holding down one combination of the buttons listed below that corresponds to the video format.

Button to press at the same time	Video format
[OSD ON] + A bus crosspoint [1]	1080/59.94i
[OSD ON] + A bus crosspoint [2]	1080/50i
[OSD ON] + A bus crosspoint [3]	720/59.94p
[OSD ON] + A bus crosspoint [4]	720/50p
[OSD ON] + A bus crosspoint [5]	1080/24psf
[OSD ON] + B bus crosspoint [1]	1080/23.98psf
[OSD ON] + B bus crosspoint [2]	480/59.94i
[OSD ON] + B bus crosspoint [3]	576/50i

￿After the POWER switch has been set to ON, keep holding down the buttons until an image is output.

[14]SYSTEM Menu

2.HiResMV

This is used to decide whether to set the high-resolution multi view mode. When SD has been selected as the system’s video format setting, images can be output at high resolution as the DVI-D output.

If this is the case, the multi view display is set for the DVI OUT connector output.

The multi view display cannot be set for the SDI OUT connector output.

On: The high-resolution multi view mode is enabled.

Off: The high-resolution multi view mode is disabled.

[14]SYSTEM Menu

3.16:9SQ

This is used to set the 16:9 squeeze mode.

It can be set when SD has been selected as the system’s video format setting.

When the 16:9 squeeze mode is selected, SD format images are provided with a border width that factors in cases where the images are to be converted into the 16:9 aspect ratio.

<Border width (graphical representation) when the squeeze mode is supported>

Squeeze (4:3) 16:9

62