Panasonic AW-HS50N operating instructions Bus crosspoint buttons 1 to, Memo

1. Parts and their functions

￿A bus crosspoint buttons [1 to 5]

￿B bus crosspoint buttons [1 to 5]

These are used to select the materials to be output to the AUX bus, PinP bus and KEY-F/S bus.

When a button is pressed and the material allocated to that button is selected, the indicator of the button lights.

Depending on the status of the BUS DELEGATION button (￿) indicators, the operation performed differs as follows.

1.While the indicators of all three buttons are off: When one of the crosspoint buttons is pressed, the materials of the buses which execute the background transitions are selected.

[B crosspoint buttons]

These are used to select the PST bus materials. When a button from [1] to [5] is pressed, the material assigned to the corresponding XPT1 to XPT5 is selected.

When a button from [1] to [5] is pressed while the SHIFT button is held down, the material assigned to the corresponding XPT6 to XPT10 is selected.

[A crosspoint buttons]

These are used to select the PGM bus materials. When a button from [1] to [5] is pressed, the material assigned to the corresponding XPT1 to XPT5 is selected.

When a button from [1] to [5] is pressed while the SHIFT button is held down, the material assigned to the corresponding XPT6 to XPT10 is selected.

￿ Memo ￿

Using the OSD menu, A/B, PGM(A)/PST(B) or PGM(B)/ PST(A) can be selected as the bus mode.

The description given above applies when the PGM(A)/ PST(B) has been selected.

￿ For details, refer to “3-1-4. Selecting the bus mode”.

2.When the indicator of the AUX button is lighted: When one of the crosspoint buttons is pressed, the AUX bus material is selected.

[B crosspoint buttons]

When a button from [1] to [5] is pressed, the material assigned to the corresponding XPT1 to XPT5 is selected.

When a button from [1] to [5] is pressed while the SHIFT button is held down, the material assigned to the corresponding XPT6 to XPT10 is selected.

[A crosspoint buttons]

When a button from [1] to [5] is pressed, PGM, PVW, KEY OUT, CLN or MV is selected respectively.

3.While the indicator of the PinP button is lighted: When a B crosspoint button is pressed, the PinP bus material is selected.

[B crosspoint buttons]

When a button from [1] to [5] is pressed, the material assigned to the corresponding XPT1 to XPT5 is selected.

When a button from [1] to [5] is pressed while the SHIFT button is held down, the material assigned to the corresponding XPT6 to XPT10 is selected.

4.While the indicator of the KEY-F/S button is lighted:

When one of the crosspoint buttons is pressed, the key fill bus or key source bus material is selected.

[B crosspoint buttons]

These are used to select the key fill bus materials. When a button from [1] to [5] is pressed, the material assigned to the corresponding XPT1 to XPT5 is selected.

When a button from [1] to [5] is pressed while the SHIFT button is held down, the material assigned to the corresponding XPT6 to XPT10 is selected.

[A crosspoint buttons]

These are used to select the key source bus materials.

When a button from [1] to [5] is pressed, the material assigned to the corresponding XPT1 to XPT5 is selected.

When a button from [1] to [5] is pressed while the SHIFT button is held down, the material assigned to the corresponding XPT6 to XPT10 is selected.

14