Panasonic AW-HS50N operating instructions External device control interfaces, LAN connection

7. External device control interfaces

7-1. LAN connection

Use LAN cables to connect the AW-HE50, AW-RP50 and host computer. When connecting the unit directly to another device, use a crossover cable. For network connections via a device such as a hub, use straight cables.

When a hub is not going to be used, ensure that the length of the LAN cable does not exceed 100 meters (328 ft.) (when a CAT5E cable is used).

￿￿For further details on the AW-HE50 and AW-RP50 connections and settings, refer to “2-2-2. Example of connections”.

￿￿For details on the functions available when connection has been made to the host computer, refer to “8. Connections with a computer”.

7-2. TALLY/GPI

The TALLY/GPI connector features five contact input ports				D-sub 15-pin, female, inch thread
for controlling the unit from an external device and seven					8	1
open collector output ports for outputting the tally and status
information from the unit to an external device.
					15	9
Pin	Signal	Input/output	Details of signal			Operation
no.
1	TALLY OUT1	Open collector output	Tally output of input image 1		A low-level signal is output during tally
2	TALLY OUT2	Open collector output	Tally output of input image 2		output.
3	TALLY OUT3	Open collector output	Tally output of input image 3
4	TALLY OUT4	Open collector output	Tally output of input image 4
5	TALLY OUT5	Open collector output	Tally output of input image 5
6	ALARM	Open collector output	Fan alarm or power alarm output		A low-level signal is output when trouble
					has occurred.
7	KEY ON	Open collector output	Key combination status output		A low level is output during key
					combinations.
8	(RESERVE)	Contact input	(Reserve)
9	NC		Not used
10	Tally Disable	Contact input	Tally signal enable/disable		This signal is enabled by the contact
					input (and disabled when open).
11	AUTO	Contact input	AUTO button of transition part		The signal is made operational by the
12	CUT	Contact input	CUT button of transition part		contact input (30 ms or more).
13	KeyON	Contact input	KEY ON button of transition part
14	PinPON	Contact input	PinP button of transition part
15	GND	Ground	Ground

Example of an open collector output connection

Ensure that the conditions given below are satisfied. Dielectric strength: Max. DC 24 V

Current:	Max. 50 mA
AW-HS50	(Max. voltage: 24 V)
	GPI Out
	ALARM Out
	(Max. current: 50 mA)
	Tally LED
	Com

Example of a contact input connection

Provide contact inputs.

AW-HS50

+3.3 V

GPI In

Com

68