Panasonic AW-HS50N operating instructions Switching the AUX output, Selecting the AUX bus material

3. Basic operations

3-7. Switching the AUX output

3-7-1. Selecting the AUX bus material

The AUX output material is selected using the A bus and B bus crosspoint buttons.

1Press the AUX button to set the crosspoint buttons to the AUX bus material selection mode.

2Select the material using the B bus crosspoint buttons.

When the buttons from [1] to [5] are pressed, the materials assigned to the corresponding XPT1 to XPT5 are selected.

When the button from [1] to [5] are pressed while the SHIFT button is held down, the materials assigned to the corresponding XPT6 to XPT10 are selected.

3Select the output signal using the A bus crosspoint buttons.

When buttons [1], [2], [3], [4] and [5] are pressed, PGM, PVW, KEY OUT, CLN or MV are selected, respectively.

4Press the AUX button to release the bus selection mode for the crosspoint buttons.

1, 4 3

AUX		PinP		KEY-F/S		MIX		WIPE	PinP ON KEY ON FTB ON
		BUS DELEGATION				TRANSITION TYPE
KEY-S									A
AUX									SHIFT
PGM		PVW		KEY OUT		CLN		MV	CUT
1	6	2	7	3	8	4	9	5 10
KEY-F									B
PinP
AUX									SHIFT
									AUTO
									BKGD

2

3-7-2. Transitions between AUX materials

By switching between the AUX bus crosspoint buttons, the MIX transition can be executed from one AUX material to another AUX material for the transition duration which has been set.

<Setting the transition duration>

[1]TIME/CBGD Menu

6.AUX BUS Trans

While the transition is underway, the indicator of the transition source button lights, and the indicator of the transition destination button blinks.

When the transition is completed, the indicator of the transition source button goes off, and the indicator of the transition destination button lights.

When another signal has been selected while a transition is underway, the processing for the transition will continue from the interim point.

This operation can also be enabled or disabled using this menu item.

45