Panasonic AW-HS50N operating instructions DVI-D output, Video delay time, Control I/O, Other

11. Specifications

DVI-D output	Digital RGB (Vertical frequency: 60 Hz):
		XGA (1024￿768), WXGA (1280￿768), SXGA (1280￿1024), WSXGA+ (1680￿1050), UXGA
		(1600￿1200), WUXGA (1920￿1200)
	Digital RGB: 1080/50P, 1080/59.94P
	￿￿ High-resolution multi view mode supported:
		Signals are also output with a high resolution even when SD has been selected as the system
		mode.
		When the high-resolution multi view mode is enabled, MV is assigned to the DVI OUT
		connector, and MV cannot be assigned to the SDI OUT 1 connectors or SDI OUT 2
		connector
	￿￿ Analog output signals are not supported.
Video delay time	1 frame (F)
	￿￿ Video signals that have passed through the PinP, multi view display, DVI-D input or DVI-D
		output will be delayed in each case by up to one frame.
Control I/O	LAN (RJ45)		Connecting cable:
	10Base-T/100Base-TX		LAN cable (category 5 or above), max. 100 m (328 ft.)
	(For IP control)		￿￿ When connecting to a hub, use a straight cable.
			Use a crossover cable when connecting the unit and
			another device on a 1:1 basis without going through a hub.
	TALLY/GPI		INPUT : 5 inputs, photocoupler sensing
	(D-sub 15-pin, female, inch		OUTPUT : 7 outputs, open collector output (negative logic)
	thread)
Other	SERVICE switch [SV/NM] (for maintenance purposes)
	Normally, this switch is used as the “NM” position.

86