Panasonic KX-NCP500 E1 Receiver Type, Receive Digits, CPC Detection TimeOut, In

E1 Receiver Type
Selects the type of signal the PBX receives from the E1 line.
This should be set to MFC-R2 when receiving ANI (Automatic Number Identification) numbers from the E1
line.
Value Range
DTMF, Pulse, MFC-R2, Undefined
Maintenance Console Location
3.42 [1-1] Slot—Port Property - E1 Port
Programming Manual References
None
Feature Guide References
1.22.1 E1 Line Service
Receive Digits
Specifies the maximum number of digits to be received from a DDI/DID number when receiving a call with the
DDI/DID number.
Value Range
0–15
Maintenance Console Location
3.42 [1-1] Slot—Port Property - E1 Port
Programming Manual References
None
Feature Guide References
None
CPC Detection Time—Out, In
Specifies the length of time required by the PBX to detect a CPC signal on outgoing or incoming trunk calls
before disconnecting the line. When None is selected here, the line will not be disconnected when a CPC
signal is not detected.
Value Range
None, 80 ´ n (n=2–75) ms
PC Programming Manual 367
3.42 [1-1] Slot—Port Property - E1 Port