Panasonic KX-NCP500 3.20 [1-1] SlotCard Property - Virtual IPCS

3.20 [1-1] Slot—Card Property - Virtual IPCS
The properties of the V-IPCS card can be specified.
Signalling (PTAP) UDP Port No. (Server)
Specifies the UDP port used by the V-IPCS card to transmit and receive PTAP (Panasonic Telephony
Administration Protocol) data. This must be changed if another network application is using the same port.
To change the value displayed here, click Common Settings and set the desired value.
Value Range
1–65535
Maintenance Console Location
3.20 [1-1] Slot—Card Property - Virtual IPCS
Programming Manual References
None
Feature Guide References
None
Signalling (MGCP) UDP Port No. (Server)
Specifies the UDP port used by the V-IPCS card to transmit and receive MGCP (Media Gateway Control
Protocol) data. This must be changed if another network application is using the same port.
To change the value displayed here, click Common Settings and set the desired value.
Value Range
1–65535
Maintenance Console Location
3.20 [1-1] Slot—Card Property - Virtual IPCS
Programming Manual References
None
Feature Guide References
None
Signalling (MGCP) UDP Port No. (IP-CS)
Specifies the UDP port used to transmit and receive MGCP (Media Gateway Control Protocol) data on the
IP-CS side. This must be changed if another network application is using the same port.
To change the value displayed here, click Common Settings and set the desired value.
200 PC Programming Manual
3.20 [1-1] Slot—Card Property - Virtual IPCS