ENGLISH
– 77
Special Features
Projector setup

Setting a projector ID

The projector has an ID number setting function that
helps the user to control two or more projectors either
simultaneously or separately with a single remote
control. The ID number is set to “ALL” by default.
Hence the ID number need not be set when only
one projector is used.

Press ▲▼ to select 1.

“PROJECTOR ID”.

PROJECTOR SETUP
PROJECTOR ID
INSTALLATION
ALL
FRONT-FLOOR
1/2

Press ◄► to switch 2.

“PROJECTOR ID”.

The setting will change as follows each time •
◄► is pressed.
2
1
64
ALL

Press MENU twice.3.

This concludes the setting procedure and •
the on-screen indications disappear and the
normal screen appears again.
Note
The ID number can be set to “ALL”, or selected •
from “1” to “64”.
If the projectors are given ID numbers, their remote •
controls must be assigned the same ID numbers,
respectively.
If the ID number of a projector is set to “ALL”, it can •
be controlled by the remote control or the PC with
any ID number.
If multiple projectors are used and some of
them have their IDs set to “ALL”, they cannot be
controlled separately from the projectors with
other ID numbers. For details on remote control ID
setting, see page 18.
▲▼◄►
ENTER
DEFAULT
MENU
This menu can be used to make a variety of
picture and projector settings.
MENU
Press to display the MAIN
MENU screen.
Press to select
“PROJECTOR SETUP”.
Press to display the
“PROJECTOR SETUP”
menu.
ENTER
MAIN MENU
PICTURE
POSITION
ADVANCED MENU
DISPLAY LANGUAGE
DISPLAY OPTION
PROJECTOR SETUP
P IN P
TEST PATTERN
SIGNAL LIST
SECURITY
NETWORK
MENU SELECT
SUB MENU