7. | Install the movable metal mesh | Movable metal mesh filter |
| filter to the filter cleaning unit. |
|
| • When reassembling, align the edge of the |
|
| movable metal mesh filter with position A. |
|
| • Hook the movable metal mesh filter onto the |
|
| gear and the rail. |
|
| • The movable metal mesh filter will be set to the |
|
| correct position after the set is installed and the |
|
| power is turned on, so it can be installed in the |
|
| middle position during reassembly without any |
|
| problem. | Rail |
|
| |
8. | Install the brush cover so that it | Brush cover fixing screws (4 places) |
| is aligned with the positioning |
|
| pin guide, and then tighten the |
|
| four brush cover fixing screws. |
|
Pin guide
9.Install the new static electric mesh filter to the filter cleaning unit.
10.Insert the filter cleaning unit into the projector, and then securely tighten the filter cleaning unit fixing screw.
•Install the air filter, and then install the filter cleaning unit by carrying out removal step 2 in reverse.
Attention
•The air filter must be installed before using the projector. If the projector is used without the air filter installed, foreign particles and dust will get inside the projector and cause problems with operation.
Filter cleaning | Static electric mesh filter |
| |
unit |
|
| Filter cleaning unit fixing screw |
Note
•If cleaning cannot remove the dust completely, then it is a sign to replace the static electric mesh filter. Consult the dealer. In addition, when the lamp unit is replaced, also replace the static electric mesh filter.
•Do not wash the static electric mesh filter with water.
•Use a neutral detergent to clean off any oil from the movable metal mesh filter.
Information
