1
3 | 1 | 2 |
2
4
Powering off the projector
1 Press POWER STANDBY “
”.
• A confirmation screen will appear.
POWER OFF
OKCANCEL
CHANGE
ENTER EXECUTE
2 Press ◄ or ► to select “OK” and press ENTER.
(or press POWER STANDBY “
” again.)
•The projection of the image stops, and the power indicator lamp of the main unit lights up orange. (The cooling fan keeps running.)
Note
•In the cooling state after the power is turned off, the lamp will not light up even if the power is turned on. To light up the lamp, turn on the power supply again when the lamp has been cooled sufficiently.
•The projector consumes approximately 15 W (240 V mode) and 10 W (120 V mode) of power even in standby mode. (Power indicator lamp lit in red)
•If the main power is mistakenly turned off during use, the lamp may not relight after power is restored. Please wait a few moments, then try again.
Be sure to set the date and time when the projector is turned on for the first time after being purchased. For details, refer to “Setting the date and time” on page 83.
Basic Operation
3 Wait until the power indicator lamp of the main unit turns to red (i.e., until the cooling fan stops). (Approx. 3 minutes)
•While the cooling fan is still running, never turn off the MAIN POWER switch, nor unplug the projector from the outlet.
4 Press the “○” marked side of the MAIN POWER switch to remove all power from the projector.
