INSTALLATION

The installations described below should be made by the qualified service personnel or system installers.

4.Remove the one screw shown below. Then turn over the printed circuit board with the front side up.

â– Installing the WV-PB6164 Data Multiplex Boards

When controlling the camera with the multiplexed control data by connecting a coaxial cable, the WV-PB6164 Data Multiplex Board must be installed in the video multiplexer.

Four data multiplex boards are included with the WJ- FS616C for cameras 1 to 4.

Please note that additional multiplex boards are available for purchase as model WV-PB6164 Data Multiplex Boards, which includes four control boards.

Caution: Before installing boards, be sure to turn off the power switch of the video multiplexer.

1.Remove the six screws on the top cover of the video multiplexer as shown in the figure.

Front

Rear

2.Remove the top cover.

3.Remove the four screws on the board as shown in the figure.

5.Pull the two knobs out from the bracket shown in the fig- ure. Then remove the bracket.

12

Page 12
Image 12
Panasonic WJ-FS616C manual Installation, Installing the WV-PB6164 Data Multiplex Boards