Panasonic WJ-FS616C manual Installations, Modifying the Front Panel

■Installations

The installations described below should be made by qualified service personnel or system installers.

●Modifying the Front Panel

Peel the tape off the supplied panel templates, then attach them on the front panel of the system controller.

●Connection with the WV-CU550C System Controller

If the supplied 6-conductor cable assembly is used, simply plug one end of the cable into the DATA IN port of the video multiplexer and the other end into the DATA OUT port on the system controller.

If you use cables assembled from locally procured materi- als, it is important that only high quality, data grade cable, suitable for RS-485 communication (shielded 4-wire twisted pair cable) is used.

Low grade cable will result in unstable operation of the sys- tem.

Video Multiplexer

System Controller

WJ-FS616C

WV-CU550C

DATA

CONTROLLER

OUT

DATA

IN

OUT

UNIT NO.

IN

TERM.

1-8

TERM

OFF

ON

ON OFF

9

0

12

8

7

43

6

5

Connection with the WV-CU550C System Controller

No. Name Data Flow No.

1	1	GND		–	1	Controller end
	2	RX(B)	FS616C ←	Controller	2	1
	3	RX(A)	FS616C ←	Controller	3
	4	TX(B)	FS616C →	Controller	4
	5	TX(A)	FS616C →	Controller	5
6						6
	6	GND		–	6

•Setting the Termination and Controller Unit Number The Termination switch and the Controller Unit Number switch are located on the rear of the system controller. When combined with the WJ-FS616C video multiplexer, always keep these switches in the positions shown below.

•Setting the Mode Selection Switch

The Mode Selection switch, that selects the operation mode of the system controller, is located on the rear of the system controller.

When combined with the video multiplexer, always keep these switches in the positions shown below.

0

TERM.MODE

ON	OFF	OFF
		ON

69