Camera Control Function
The camera control is only available while the camera image is displayed in single spot on the selected monitor screen.
Note: When controlling the camera with multiplexed control data by connecting a coaxial cable, you should install the optional
■Camera Selection
1.Select an either spot or multiscreen monitor by pressing the [F2] or [F1] button on the controller.
2.Select the camera mode (VCR off) by pressing the [F4] button on the controller.
3.Select the desired camera number by pressing the Numeric keys, then press the [CAM(SET)] key.
The selected camera image is displayed in single spot on the active monitor screen.
3.Press the [ZOOM] button to adjust the lens zoom to achieve the desired image while observing the active monitor.
Press this button to the [TELE] position to optically bring an object closer.
Pressing to the [WIDE] position has the reverse effect.
ZOOM
TELE
WIDE
4.Press the [IRIS CLOSE/OPEN] buttons to close/open the lens iris. Adjust the lens iris by pressing these but- tons to obtain the proper image exposure.
IRIS
CLOSEOPEN
Pressing these buttons at the same time will reset the lens iris to the factory default setting.
■Controlling Camera Site Accessories
For controlling camera site accessories, normally combina- tion camera equipped with the specific feature or a speci- fied receiver are required to utilize these functions.
●Lens Control
Confirm that the specified lens with power zoom/focus func- tions is mounted on the camera.
1.Select the desired monitor and camera referring to the Camera Selection procedure described above.
2.Press the [FOCUS] button to adjust the lens focus to achieve a sharply focused image while observing the active monitor.
If the specified camera with auto focus feature is used in the system, you can adjust the lens focus automati- cally by pressing the [AF] button.
FOCUS
NEARAF
FAR
●Pan/Tilt Control (Manual Operation)
1.Select the desired monitor and camera referring to the Camera Selection procedure described above.
2.Move the joystick to move the pan/tilt head in the desired direction.
If the joystick is positioned in between UP and RIGHT, the pan/tilt head moves diagonally upward and to the right.
The moving speed of the pan/tilt head depends on the tilt of the joystick.
●Pan/Tilt Control (Preset Operation)
The following function requires the use of cameras equipped with the specific feature.
1.Select the desired monitor and camera referring to the Camera Selection procedure described above.
2.Press the
| 1 | 2 | 3 |
PRE- | 4 | 5 | 6 |
POSI |
7 8 9
MON 0 CAM
UNIT/ESC SET
72
