6.Set the jumper connector, that is located at the top left of the board, to the position shown below where the board is installed.
Jumper Connector
■Tally Output Setting
Allows you to use the Alarm Input terminal on the ALARM/REMOTE port as Tally Output terminal by changing two internal connections.
It is enabled use that mingles alarm input and tally out- put.
1.Disassemble the video multiplexer as described for installing the Data Multiplex Boards on page 12.
|
|
| Board Connector |
Initial State |
|
| Installed State |
2 | 8 | 2 | 8 |
1 | 7 | 1 | 7 |
7.Insert the board in the board connector. Confirm that the position is correct and it is placed firmly.
ALM
CN33 |
|
| CN37 |
10 | 1 | 10 | 1 |
CN32 |
|
| CN36 |
9 | 1 | 9 | 1 |
|
| TLY |
|
2. Move the two connectors from the ALM side to the TLY side as shown above.
The relation between the connector numbers and chan- nel numbers is shown in the table below.
| Alarm Input | Tally Output |
|
|
|
CH9 - CH16 | CN33 | CN37 |
CH1 - CH8 | CN32 | CN36 |
|
|
|
8.After installing the boards, secure them by tightening the screws and knobs shown above.
Note: Some settings for the VD2 signal and control data will be necessary from the setup menu of the video multiplexer.
Refer to Cable Compensation/VD2/Data Setup on page 41 for details.
13
