Paradyne 3616, 3615 manual Dbm

COMSPHERE DualFlow Data Service Units

Table C-9

(2 of 2)

Dial Backup Error Messages

Message

Notify NMS 1

Condition

Action

DBM:No Ringing	No	DBM is not getting ringback	Look for line problems. If conditions are
		from the other end.	good and no problem is found, call
			telephone company and report the
			problem.
DBM:	No	Call attempt failed for	1.	Check DBM for proper operation by
NotConnected		unspecified reasons.		running a Device Test.
			2.	Check the DBM's configuration options
				to ensure that DBM is enabled.
			3.	If you cannot correct the problem,
				contact your service representative.
DBM:ProtoErrnn	No	Protocol error (nn is the error	1.	Check the lines. Line quality has
		number) by the 2-wire Switched		degraded. (A call to the central office
		56 DBM.		to perform diagnostic tests may be
				required.)
			2.	If the line quality is good, note the
				protocol error number and whether the
				DBM was originating or answering a
				call, then contact your service
				representative.
DBM:	Yes	The rate in the calling and	Check speed configured in both units.
RateMismatch		called DBM or modem are not
		compatible.
DBM:SecurityFail	No	Passwords in calling and called	1.	Make sure that both DBMs have
		DBM do not match.		compatible security options.
			2.	Make sure that both DBMs have the
				proper password.

1If Yes, an error message is reported to the NMS if the NMS initiated the dial command.

C-12 December 1996 3615-A2-GB20-20