Paradyne 3616, 3615 manual Comsphere 3000 Series Carrier, Rear View

Installing the Model 3616 DualFlow DSU

Installing the DSU

Prior to installing the Model 3616 DualFlow DSU, install a rear connector plate onto the rear of the COMSPHERE 3000 Series Carrier (Figure 3-2). Only after this procedure can the DSU be installed or de-installed by simply removing it from the carrier.

.Procedure

1.At the rear of the carrier, set the tab on the rear connector plate into one of the slotted grooves on the carrier's backplane. Loosely fasten the screws. Make sure the rear connector plate uses the same slot position intended for the DSU.

2.Loosely fasten the screw attached to the rear connector plate, allowing for slight adjustment that may be needed when installing the DSU.

3.Change any default hardware strap settings that may be required before installing the DSU.

Figure 3-2. COMSPHERE 3000 Series Carrier, Rear View

3615-A2-GB20-20 December 1996 3-5