Paradyne 3616, 3615 manual Connecting the DSU to a Router, Router Connection

Installing the Model 3615 DualFlow DSU

Connecting the DSU to a Router

The DualFlow DSU transmits user data through its V.35 interface and diagnostic or user data through its EIA-232-D/V.24 interface. Cabling is based upon the preset configuration (SyBC, SyBT, or DiDg) selected in the Opts subbranch (Config branch).

Figure 2-7 shows the DualFlow DSU's rear panel. Refer to this figure as you connect the DSU to the router. Appendix E shows examples common to the DSU-to- router application configurations.

.Procedure

1.Connect the plug end of the router's V.35 cable to the DSU's V.35 connector.

Tighten the two holding screws.

2.Connect the other end of the router's V.35 cable to the router's primary serial port.

Tighten any holding screws.

3.Connect the plug end of the router's EIA-232 cable to the DSU's EIA-232-D/V.24 connector.

Tighten any holding screws.

4.Connect the other end of the router's EIA-232 cable to the router:

•If the DSU is to be configured using the SyBC or SyBT configuration, connect to the router's secondary serial port.

•If the DSU is to be configured using the DiDg configuration, connect to the router's console port.

Tighten any holding screws.

DiDg CONFIGURATION:

TO ROUTER

CONSOLE PORT

(ROUTER-MANAGEMENT

DATA)

	EIA-232-D/V.24	SyBC OR SyBT
		CONFIGURATION:
	INTERFACE
		TO ROUTER
		SECONDARY SERIAL PORT
	V.35	(BACKUP OR OVERFLOW
	INTERFACE	DATA)
DSU	CC
		TO ROUTER
	LOW	PRIMARY SERIAL PORT
		(USER DATA)
	VOLTAGE
	AC POWER
	IN

TO NMS (CONTROL

DEVICE

ONLY)

		DEVICE
3000HUBBING		-F3-300
MODEL	#3000

496-14498-01

Figure 2-7. Router Connection

3615-A2-GB20-20 December 1996 2-9