Unit Configuration
Saving Configuration Options
CAUTION
Be extremely careful when saving configuration options to avoid saving them to the wrong location.
To save edited configuration options:
.Procedure
1.From any configuration option in any option set,
press the 
key to return to the Edit/Save submenu.
2.Press the F1 key below SAVE.
3.Select area (Activ, Remt, Usr1, etc.) on the Save to screen.
•If Activ is selected, your changes take effect immediately.
•If Usr1, Usr2, or Usr3 is selected, your changes are stored for future use.
•If the unit is a control and Remt is selected, the complete set of configurations (all option sets available to the unit) are sent to the tributary and saved to its Activ area.
Remember that you cannot save to the factory- loaded configuration areas.
Example Using the DCP
In this example, load the configuration options stored in the DiDg area. Change RTS Cntrl (in the DSU Port option set) from FrcOn to DTE. Then, save the changes to the Usr1 area and return to the
.Procedure
Press the DCP keys indicated by the shading.
V.35 | DSU | 56 C |
Local | Remot |
|
F1 | F2 | F3 |
Local Mode:
Stat Bckup Test
F1 F2 F3
Local Mode:
Bckup Test Confg
F1 F2 F3
Configure:
Opts PollL Dir
F1 F2 F3
Load from: |
| |
Activ | Remt | Usr1 |
F1 | F2 | F3 |
December 1996 |
