Operating the DSU
Entering a Telephone Number
For the following example, add a dial string (telephone number) to Backup Directory 1. The number to be entered is
To add or change a telephone number:
.Procedure
1.Select Local.
2.Press the 
key to display Confg (Configuration branch).
3.Select Confg.
4.Select Dir if entering a telephone number into the Backup Directory.
Press the 
key to display then select Phone if entering the local DSU's telephone number. This telephone number is entered similarly to entering a number into Dir.
5.Select Chang (F1) to add or change a telephone number.
The Enter Dir screen appears.
Press the F1 key ( ↑ ) to increment the Directory entry indicator (the default is 1). For this example, assume that you are entering your first directory entry.
6.Select Load (F2).
The Directory entry appears on the first line; the cursor is positioned in the first position of the currently empty Directory.
1 :
Undo
F1 F2 F3
If the number had been entered previously, that number would appear on the first line, following the colon (:).
For numeric screens, the following applies:
ÐPress the F1 key ( ↑ ) to increment the digit.
ÐPress the F2 key ( ↓) to decrement the digit.
ÐPress the 
or 
keys to move the blinking cursor one position to the left or right.
ÐPress the F3 key (Undo) to restore the number as it was first displayed so you can start over.
Refer to Table
7.Press the F1 key until the number 5 appears.
8.Press the 
key to move to the next position.
9.Repeat the process until all numbers in the telephone number have been entered.
1 : 5 5 5 1 2 3 4
Undo
F1 F2 F3
NOTE
A dial string cannot have any separating characters or spaces (i.e.,
10.Press the 
key to return to the Enter Dir screen.
11.Press the F3 key to Save the entry.
12.Verify that the number was loaded by pressing the 
key again and selecting Load (F2).
The telephone number should appear as entered, or you can repeat the procedure to edit/correct your entry.
December 1996 |
