Paradyne 9123 manual Alarm Conditions 4 What It Indicates What To Do

Troubleshooting

Table 6-1. Alarm Conditions (4 of 4)

Alarm Condition		What It Indicates	What To Do
Primary Clock Failed		A failure of the configured	H Check that the network cable
		primary clock source for the	is securely attached at both
		unit was detected and the	ends.
		secondary clock is	H Contact your network provider.
		providing the timing for the
		unit.
		This condition clears when
		the configured primary
		clock is restored.
Self-Test Failure		The unit did not pass its	H Reset the unit.
		basic verification tests	H Contact your service
		when it was powered on or
			representative.
		reset.
SLV Timeout,		An excessive number of	Verify that the network LMI is up.
DLCI nnnn,		SLV communication	If it is, contact your network
frame relay link 1, 2		responses from the remote	service provider.
		system have been missed
		on the specified multiplexed
		DLCI and link.
		If the frame relay link is
		Net1-FR1, the timeout is on
		the network FrameRly1
		timeslot assignment.
		When a hardware bypass-
		capable device has been
		detected at the other end of
		the PVC and this condition
		occurs, only user data for
		EDLCI 0 will be transmitted
		as long as the condition
		exists.
Two Level-1 Users		Another user with Level-1	Wait until no other Level-1
Accessing Device		security access is currently	users are accessing the unit if
		accessing the unit.	testing or configuration will be
		Be aware that actions of	performed..
		the other user may override
		your test commands and
		configuration changes.
Yellow at Network 1		A yellow alarm signal is
		received on the network
		interface.
		H Network cable problem.	H Check that your network cable
			is securely attached at both
			ends.
		H T1 facility problem.	H Contact your network provider.
1	nnnn indicates a DLCI number of 16 through 1007.
2	frame relay link is one of the following:

± Net1-FR1. The frame relay link specified for the network interface, Network 1.

± Port-1. The frame relay link associated with the user data port.

6-10 May 2000 9123-A2-GB20-00