Paradyne 9123 manual Network Physical Interface Options 2, Bit Stuffing, Transmit Timing

Configuration

Table 3-4. Network Physical Interface Options (2 of 4)

Bit Stuffing

Possible Settings: 62411, Disable

Default Setting: 62411

Determines the type of bit insertion to provide ones density requirements for data transmitted to the network.

Display Conditions ± This option does not appear when Line Coding Format is set to B8ZS.

62411 ± Inserts a one in the data after 15 consecutive zeros are received or the density of ones falls below 12.5%. This setting complies with AT&T TR 62411, but is not recommended for frame relay data because it inserts errors in the data traffic.

Disable ± Disables bit stuffing. Ones density is not enforced on data sent to the network.

Transmit Timing

Possible Settings: System, Interface

Default Setting: System

Allows transmit timing to be selected from either the system master clock source or from the currently selected interface.

System ± Transmit timing is derived from the current system clock source (see Table 3-3,General System Options).

Interface ± Transmit timing is derived from this interface.

NOTE: When Interface is configured, the clock must be synchronized to the system clock source.

Network Initiated LLB

Possible Settings: Enable, Disable

Default Setting: Enable

Allows the initiation and termination of the line loopback (LLB) to be controlled by the receipt of LLB-Actuate and LLB-Release commands from the network.

Enable ± LLB is controlled by LLB-Actuate and LLB-Release commands. Receiving a LLB-Actuate command causes the FrameSaver unit to enter a line loopback (provided an LLB can be performed in the FrameSaver unit's current state). Receiving an LLB-Release command terminates the LLB.

Disable ± The FrameSaver unit ignores the LLB-Actuate and LLB-Release commands.

NOTE: When disabled, the system is not in compliance with ANSI T1.403 or AT&T TR 62411.

3-24 May 2000 9123-A2-GB20-00