Paradyne 9123 Setting Up So the Router Can Receive RIP, Configuration → Data Ports → Dlci Records

Configuration

Setting Up So the Router Can Receive RIP

Using the system's standard Routing Information Protocol (RIP) feature, routing information is passed to the router over the management PVC, so the router can learn routes to FrameSaver FLEX and SLV devices. Node IP information should be set up (see Configuring Node IP Information).

"Procedure

1.Configure the router to receive RIP.

For example, if using a Cisco router, configure config-t, router RIP, int serialx, IP RIP Receive version 1, then ctl-z WR.

2.Create a Standard DLCI for the user data port.

Configuration → Data Ports → DLCI Records

3.Create a Management PVC using the user data port DLCI just configured. Configuration → Management and Communication → Management PVCs

4.Set Primary Link RIP to Standard_Out, and Save the configuration.

Refer to Table 3-7,DLCI Record Options, and Table 3-10.Management PVC

Options for configuration information.

Entering System Information and

Setting the System Clock

Select System Information to set up or display the general SNMP name for the unit, its location, and a contact for the unit, as well as to set the system clock.

Main Menu → Control → System Information

The following information is available for viewing. Save any entries or changes.

If the selection is . . .	Enter the . . .
Device Name	Unique name for device identification of up to 20 characters.
System Name	SNMP system name; can be up to 255 characters.
System Location	System's physical location; can be up to 255 characters.
System Contact	Name and how to contact the system person; can be up to
	255 characters.
Date	Current date in the month/day/year format (mm/dd/yyyy).
Time	Current time in the hours:minutes format (hh:mm).

NOTE:

To clear existing information, place the cursor in the Clear field (Tab to the

Clear field) and press Enter.

See Chapter 4, Security and Logins, to set up and administer logins.

3-10 May 2000 9123-A2-GB20-00