Paradyne 9123 manual Device Messages 5 What It Indicates What To Do, Changes? prompt

Operation and Maintenance

Table 5-5. Device Messages (5 of 5)

Message	What It Indicates	What To Do
Save Cancelled	Changes were made on the	No action is needed.
	Easy Install screen, but
	when it came to saving the
	changes, the Esc key was
	pressed or No was entered
	in response to the Save
	Changes? prompt.
Test Active	No higher priority health	H Contact service provider if test
	and status messages exist,	initiated by the network.
	and a test is running.	H Wait until the test ends and
		message clears.
		H Cancel all tests from the Test
		screen (Path: main/test).
		H Stop the test from the same
		screen the test was started
		from.
User Interface	Two Telnet sessions are	H Wait and try again.
Already in Use	already in use when an	H Contact one of the IP address
	attempt to access the
		user and request that they log
	menu-driven user interface
		off.
	through the COM port is
	made.
	IP addresses and logins of
	the users currently
	accessing the interface are
	also provided.
User Interface Idle	Previously active session is	Log on to the FrameSaver unit.
	now closed/ended, and
	access via the COM port is
	now available.
	Session has been ended	No action is needed.
	due to timeout.
Value Out of Range	CIR entered for the DLCI is	Enter a valid CIR (0 ± 1536000).
	a number greater than the
	maximum allowed.
	Excess Burst Size entered	Enter a valid Excess Burst Size
	for the DLCI is a number	(0 ± 1536000).
	greater than the maximum
	allowed.
	DLCI Number entered is	Enter a valid number
	less than 16 or greater	(16 ± 1007).
	than 1007.

9123-A2-GB20-00 May 2000 5-11