Paradyne FrameSaver DSL, 9783 manual Alarm Conditions 3 What It Indicates What To Do

Troubleshooting

Table 8-1. Alarm Conditions (3 of 4)

Alarm Condition		What It Indicates	What To Do
Loss of Cell		The ATM Transmission	Contact your network provider.
Delineation, atm link		Convergence (TC) layer
		has been in an LCD state
		for one minute, or the
		number of Out of Cell
		Delineation (OCD)
		delineation events has
		exceeded the
		user-specified threshold.
Network Com Link		The communication link for	Check the router connected to
Down		the COM port is down and	the COM port.
		the COM port is configured
		for Net Link.
OOF at Network 1		An Out of Frame (OOF)
		condition is detected on the
		network interface.
		H Incompatible framing	H Check that the framing format
		format between the	for the network interface is
		network and the	correct.
		FrameSaver unit.
		H Network cabling	H Check that the network cable
		problem.	is securely attached at both
			ends.
Self-Test Failure		The unit did not pass its	H Reset the unit.
		basic verification tests	H Contact your service
		when it was powered on or
			representative.
		reset.
SLV Timeout,		An excessive number of	Verify that the network LMI is up.
DLCI nnnn,		SLV communication	If it is, contact your network
frame relay link 1, 2		responses from the remote	service provider.
		system have been missed
		on the specified multiplexed
		DLCI and link.
		If the frame relay link is
		Net1-FR1, the timeout is on
		the network FrameRly1
		timeslot assignment.
		When a hardware bypass-
		capable device has been
		detected at the other end of
		the PVC and this condition
		occurs, only user data for
		EDLCI 0 will be transmitted
		as long as the condition
		exists.
1	nnnn indicates a DLCI number of 16 through 1007.
2	frame relay link is one of the following:
	± Net1-FR1. The frame relay link specified for the network interface, Network 1.
	± Port-1. The frame relay link associated with the user data port.

9783-A2-GB20-00 July 2000 8-9