Paradyne 9783, FrameSaver DSL manual Alarm Conditions 2 What It Indicates What To Do

Troubleshooting

Table 8-1. Alarm Conditions (2 of 4)

Alarm Condition	What It Indicates	What To Do
LMI Down,	The Local Management	For the network interface:
frame relay link 2	Interface is down for the	H If LMI was never up, verify
	specified frame relay link.
		that the LMI Protocol setting
		reflects the LMI type being
		used.
		H If LMI was never up:
		± Verify that the proper time
		slots have been configured.
		± Verify that the LMI Protocol
		setting reflects the LMI type
		being used.
		H Verify that Frame Relay
		Performance Statistics show
		LMI frames being transmitted.
		If all of the above have been
		verified and the physical link is
		not in Alarm, contact your
		network provider.
LMI Down,	The Local Management	For user data port:
frame relay link 2	Interface is down for the	H Check that the DTE cable is
	specified frame relay link.
		securely attached at both
		ends.
		H Verify that Transmit Clock
		Source and Invert Transmit
		Clock options are properly
		configured.
		H Verify that Frame Relay
		Performance Statistics show
		LMI frames being received. If
		no frames are being received:
		± Check the attached device.
		± Verify that the LMI Protocol
		setting reflects the LMI type
		being used.
LOS at Network 1	A Loss of Signal (LOS)
	condition is detected on the
	network interface. Clears
	when a signal is detected.
	H Network cable problem.	H Check that the network cable
		is securely attached at both
		ends.
	H No signal is being	H Check far-end FrameSaver
	transmitted at the far-end	unit status.
	FrameSaver unit.

2 frame relay link is one of the following:

± Net1-FR1. The frame relay link specified for the network port, Network 1.

± Port-1. The frame relay link associated with the user data port.

8-8 July 2000 9783-A2-GB20-00