Paradyne 9783, FrameSaver DSL manual Node IP Options 2

Configuration Options

Table 4-11. Node IP Options (2 of 3)

Default IP Destination

Possible Settings: None, COM, Ethernet, PVCname

Default Setting: None

Specifies an IP destination to route data that does not have a specifically defined route.

Examples:

HIf the default IP network is connected to the communications port, select COM.

HIf the default IP network is connected to a far-end device over the management PVC named London for the remote device located in the London office, select the PVC name London (as defined by the Name configuration option, Table 4-12, Management PVCs Options).

NOTE: If the link to the IP destination selected as the default route becomes disabled or down, the unrouteable data will be discarded. Make sure that the link selected is operational, and if that link goes down, change the default destination.

CAUTION: Use care when configuring a default route to an interface that has a subnet route configured at a remote end where the NMS, router, LAN adapter, terminal server, etc. is connected. Communicating with an unknown IP address on the subnet will cause temporary routing loops, which will last 16 iterations times the retry count.

None ± No default network destination is specified. Unrouteable data will be discarded. This is the recommended setting.

COM ± Specifies that the default destination is connected to the COM port. Only appears when Port Use is set to Net Link (see Table 4-18,Communication Port Options).

Ethernet ± Specifies that the default destination is connected to the Ethernet port. Only appears when the Ethernet port's Interface Status option is enabled. When selected, the Default Gateway Address must also be configured (see Table 4-17,Ethernet Port Options).

PVCname ± Specifies a name for the management PVC. Only appears when a management PVC name is defined for the node. For example, when the network is connected to a remote device located in the London office, London can be specified as the PVC name, which is the link between the local FrameSaver unit and the one located in London. London would appear as one of the available selections.

4-26 July 2000 9783-A2-GB20-00