D e f a u l t N e t w o r k
The default network option allows you to reset the print server to default settings or factory default settings.
♦If you select default setting, any defaults set using the SET DEFAULT Telnet console command are restored.
♦If you select factory default, the print server is reset to factory defaults. See “Factory Defaults” for the list of default values. When the print server is reset to factory defaults, you must reconfigure all your specific network settings, including IP address, SSID, etc.
To change the setting, from the Main Menu: Select Setup, Network. Then follow these steps.
1. Press or until you see
NETWORK
Default Network
2.Press Enter/Pause.
Default Network
Default Setting
3.After you display the option you need, press Enter/Pause. The print server is reset to your defaults or factory defaults.
4.Press Escape/Clear until you see the Main Menu.
5.Turn off the printer and turn it back on to initialize the factory settings.
Note: Depending on your printer’s boot method, the IP address may be automatically assigned when you turn on the printer.
The new IP address may not be the same as the previous one.
