Line Commands

Set Line Interface

Description

Configures line interface (hardware) parameters.

User Level

Admin

Syntax

set line .<number>* interface eia-232 [monitor-dcd onoff]

 

[monitor-dsr onoff] [flow nonesofthardboth]

 

[speed 507511013415020030060012001800240048009600

 

19200384005760011520023040028800custom <baud_rate>]

 

set line interface eia-422 [flow nonesofthardboth]

 

[speed 50751101341502003006001200180024004800

 

960019200384005760011520023040028800custom <baud_rate>]

 

set line interface eia-485 [tx-driver-control autorts]

 

[flow nonesoft]

 

[duplex fullduplex half [echo-suppression onoff]]

 

[speed 50751101341502003006001200180024004800

 

960019200384005760011520023040028800custom <baud_rate>]

Options

eia-232 eia422 485

 

Specifies the type of line that is being used with the IOLAN. Select either EIA-232,

 

EIA-422, or EIA-485(TS2 supports only EIA-232).

 

monitor-dcd

 

Specifies whether the RS-232 signal DCD (Data Carrier Detect) should be monitored.

 

This is used with modems or any other device that sends a DCD signal. When it is

 

monitored and the IOLAN detects a DCD signal, the line service is started. Default is

 

Off. If both Monitor DCD and Monitor DSR are enabled, both signals must be detected

 

before the line service is started.

 

monitor-dsr

 

Specifies whether the RS-232 signal DSR (data set ready) should be monitored. This is

 

used with modems or any device that sends a DSR signal. When it is monitored and the

 

IOLAN detects a DSR signal, the line service is started. Default is Off. If both Monitor

 

DCD and Monitor DSR are enabled, both signals must be detected before the line

 

service is started.

 

flow

 

Defines whether the data flow is handled by the software (Soft), hardware (Hard),

 

Both, or None.

 

tx-driver-control

 

Used with a EIA-485serial interface, if your application supports RTS (Request To

 

Send), select this option. Otherwise, select Auto. Default is Auto.

 

duplex

 

Specify whether the line is Full Duplex (communication both ways at the same time) or

 

Half Duplex (communication in one direction at a time).

44

IOLAN DS1/TS2 CLI Reference Guide, Version 4.1

Page 44
Image 44
Perle Systems 5500208-41 manual Set Line Interface