Packet Forwarding Commands
force-transmit-timer
When the specified amount of time, in milliseconds, elapses after the first character is received from the serial port, the packet is transmitted. After a packet is transmitted, the next character received starts the timer again. A value of zero (0) ignores this parameter. Valid values are
forwarding-rule
Determines what is included in the Frame (based on the EOF1 or EOF1/EOF2) or
Packet (based on Trigger1 or Trigger1/Trigger2). Choose one of the following options:
z
z
z
z
idle-timer
The amount of time, in milliseconds, that must elapse between characters before the packet is transmitted to the network. A value of zero (0) ignores this parameter. Valid values are
packet-size
The number of byte that must be received from the serial port before the packet is transmitted to the network. A value of zero (0) ignores this parameter. Valid values are
sof1
When enabled, the Start of Frame character defines the first character of the frame, any character(s) received before the Start of Frame character is ignored. Valid values are in hex
sof2
When enabled, creates a sequence of characters that must be received to create the start of the frame (if the SOF1 character is not immediately followed by the SOF2 character, the IOLAN waits for another SOF1 character to start the SOF1/SOF2 character sequence). Valid values are in hex
start-frame-transmit
When enabled, the SOF1 or SOF1/SOF2 characters will be transmitted with the frame. If not enabled, the SOF1 or SOF1/SOF2 characters will be stripped from the transmission.
Show Packet-Forwarding Line
Description | Shows the |
User Level | Admin |
Syntax | show |
59
