Line Commands

echo-suppression

This parameter applies only to EIA-485 Half Duplex mode. All characters will be echoed to the user and transmitted across the serial ports. Some EIA-485 applications require local echo to be enabled in order to monitor the loopback data to determine that line contention has occurred. If your application cannot handle loopback data, echo suppression should be On. The default is echo suppression Off.

speed

Specifies the baud rate of the line; keep in mind that speed is affected by the length of the cable. You can also specify a custom baud rate; valid values are 50 - 1843200.

Set Line Service

Description Sets the service for the line. For services that need further configuration, see Line Service Commands on page 48 to find the Line Service that you want to configure.

User Level Admin

Syntax set line .<number>* service bidir <config_host> <server_port> <host_port>

set line .<number>* service direct raw <config_host> <host_port>

set line .<number>* service silent raw <config_host> <host_port>

[multihost allbackup <config_backup_host> <host_port>none]

set line .<number>* service directsilent telnet <config_host> [<host_port>]

set line .<number>* service reverse raw [multihost onoff]telnet <server_port>

set line .<number>* service client-tunnel <config_host> <host_port>

set line .<number>* service server-tunnel <server_port>

set line .<number>* service dsloginudpvmodemmodbus-master modbus-slavecustom-app

set line .<number>* service trueport client-initiated off <config_host> <host_port> [signal-active onoff] [multihost allbackup <config_backup_host> <host_port>none]

set line .<number>* service trueport client-initiated on <server_port> [signal-active onoff] [multihost onoff]

Options bidir

This service allows the IOLAN to listen for incoming TCP connection and if needed, initiate a TCP connection.

<config_host>

The name of the target host. The host must exist in the IOLAN host table.

<server_port>

The IOLAN port number.

45

Page 45
Image 45
Perle Systems 5500208-41 manual Set Line Service, Confighost, Serverport