Perle Systems 5500208-41 manual Global I/O Commands, Set IO UDP

9 I/O Commands

Chapter 9

This chapter defines all the CLI commands associated with configuring the IOLAN’s I/O parameters.

Global I/O Commands

Set IO UDP

Description	Sets the UDP settings for I/O unicast messages.
User Level	Admin
Syntax	set io udp [mode onoff]
	[broadcast-interval <broadcast_interval>]
	set io udp entry 1234 disabled
	set io udp entry 1234 <udp_port> <start_ip> [<end_ip>]
Options	mode
	Enables/disables UDP broadcast of I/O channel status (data).
	broadcast-interval
	Enter the interval, in seconds, for UDP broadcasts of I/O channel status (data). Valid
	values are 1-9999. Default value is 30 seconds.
	entry
	You can specify up to four sets of UDP IP address that will receive the I/O unicast.
	udp_port
	The UDP port that the IOLAN will use to relay messages to servers/hosts.
	start_ip
	The first host IP address in the range of IP addresses (for IPV4 or IPV6) that the
	IOLAN will listen for messages from and/or send messages to.
	end_ip
	The last host IP address in the range of IP addresses (for IPV4, not required for IPV6)
	that the IOLAN will listen for messages from and/or send messages to.

IOLAN DS1/TS2 CLI Reference Guide, Version 4.1 77