Perle Systems SCS, STS manual Port Iolan DB9, Port Iolan SDS1M Modem

Introduction

1-Port IOLAN DB9

To change the settings, do the following:

1.Unplug the IOLAN from the electrical outlet and disconnect everything from the box.

2.Open the case by unscrewing the two side screws, one on each side, and lifting off the top of the case. You should see the following:

DB9	J9
Serial	J1

Screw

DIP	Power
Switch	Reset
	RJ45

Screw

3.To turn line termination on, locate and jumper both J1 and J9.

4.Close the IOLAN case by replacing the case lid and the two screws. You can now power it on with the new settings.

2-Port IOLAN SDS1M (Modem)

To change the settings, do the following:

1.Unplug the IOLAN from the electrical outlet and disconnect everything from the box.

2.Open the case by unscrewing the two side screws, one on each side, and lifting off the top of the case. You should see the following:

			Screw
			J4 Pin1
	RJ45 Serial	J8
		J7
Modem

Screw

DIP	Power
Switch	Reset
	RJ45

3.To change the power pin out, locate J4. For the fixed 5V DC output, jumper pins 1 and 2. For the output to equal the external adapter input, jumper pins 2 and 3.

4.To turn line termination on, locate and jumper both J7 and J8.

5.Close the IOLAN case by replacing the case lid and the two screws. You can now power it on with the new settings.

Setting Jumpers 363