Perle Systems STS, SCS manual Act As Tunnel, Client Default Disabled Host Name

Serial Port Profiles

General Tab Field Descriptions

Configure the following parameters:

Act As Tunnel	The IOLAN will listen for an incoming connection request on the specified
Server	Internet Address on the specified TCP Port.
	Default: Enabled
TCP Port	The TCP port that the IOLAN will listen for incoming connection on.
	Default: 10000+serial port number; so serial port 5 is 10005.
Enable TCP	Enables a per-connection TCP keepalive feature. After the configured number
Keepalive	of seconds, the connection will send a gratuitous ACK to the network peer,
	thus either ensuring the connection stays active OR causing a dropped
	connection condition to be recognized.
	This parameter needs to be used in conjunction with Monitor Connection
	Status Interval parameter found in the Serial, Advanced, Advanced Settings
	tab. The interval specifies the inactivity period before "testing" the connection.
	Default: Disabled
Act as Tunnel	The IOLAN will initiate the connection the Tunnel Server.
Client	Default: Disabled
Host Name	A preconfigured host name that is associated with the IP address of the Tunnel
	Server.
TCP Port	The TCP port that the IOLAN will use to connect to the Tunnel Server.
	Default: 10000+serial port number; so serial port 5 is 10005.

152 IOLAN SDS/SCS/STS User’s Guide, Version 3.6