Perle Systems SCS Default 100 ms, Default 200 ms, Default Disabled Advertise DHCPv6, Prefixes

IP Settings

Monitoring Interval (SCS only) The interval in which the active interface is checked to see if it is still communicating.

Default: 100 ms

x

Recovery Delay (SCS only) The time that the IOLAN will wait to make the secondary interface (Ethernet 2) active after it has been detected as up.

Default: 200 ms

Enable IPv6 Router When enabled, the IOLAN will periodically send IPV6 Router Advertisement

Advertisement messages and respond to Router Solicitation messages. The Router Advertisement message can be configured to contain any of the following information:

zDHCPv6—Use the DHCPv6 server to obtain additional IPV6 address(es) and configuration parameters.

zDHCPv6 Configuration Options—Use DHCPv6 server to obtain additional configuration parameters.

zNetwork Prefixes—Advertise the selected custom configured network prefixes.

Default: Disabled

Advertise DHCPv6	When enabled, the Router Advertisement message indicates to use the
	DHCPv6 server for obtaining additional IPv6 addresses and configuration
	parameters.
	Default: Disabled
Advertise DHCPv6	When enabled, the Router Advertisement message indicates to use the
Configuration	DHCPv6 server to obtain additional configuration parameters.
Options	Default: Disabled
Advertise the	The network prefix of the IPV6 addresses created in the IPv6 Settings tab in
following Network	the Custom IPv6 Address List are included in the Router Advertisement
Prefix(es)	message. You can choose to enabled or disable specific network prefixes from
	being advertised to hosts.
	Default: Enabled
Interface 1	Define the Ethernet connection speed (desktop models can support up to 100
Hardware Speed	Mbps and rack models can support up to 1000 Mbps).
and Duplex	Data Options:
	z Auto—automatically detects the Ethernet interface speed and duplex
	z 10 Mbps Half Duplex
	z 10 Mbps Full Duplex
	z 100 Mbps Half Duplex
	z 100 Mbps Full Duplex
	z 1000 Mbps Full Duplex

Interface 2

Hardware Speed

and Duplex

Default: Auto

Define the Ethernet connection speed (available on SCS models only).

Data Options:

zAuto—automatically detects the Ethernet interface speed and duplex

z10 Mbps Half Duplex

z10 Mbps Full Duplex

z100 Mbps Half Duplex

z100 Mbps Full Duplex

z1000 Mbps Full Duplex

Default: Auto

87