Perle Systems SCS, STS manual Initiate Connection, Received on the serial port

Serial Port Profiles

TCP Port	The TCP port that the IOLAN will use to listen for incoming connections.
	Default: 10000 plus the serial port number, so serial port 5 would have a
	default of 10005
Allow Multiple	When this option is enabled, multiple hosts can connect to the serial device that
Hosts to Connect	is connected to this serial port.
	Default: Disabled
Connect To	When enabled, the IOLAN initiates communication to the Workstation/Server.
	Default: Disabled
Host Name	The name (resolvable via DNS) or IP address of the configured host the
	IOLAN will connect to.
TCP Port	The TCP Port that the IOLAN will use to communicate to the client.
	Default: 0
Connect to	When enabled, allows a serial device connected to this serial port to
Multiple Hosts	communicate to multiple hosts.
	Default: Disabled
Define Additional	Click this button to define the hosts that this serial port will connect to. This
Hosts Button	button is also used to define the Primary/Backup host functionality.
Initiate Connection	If the serial port hardware parameters have been setup to monitor DSR or
Automatically	DCD, the host session will be started once the signals are detected. If no
	hardware signals are being monitored, the IOLAN will initiate the session
	immediately after being powered up.
	Default: Enabled

Initiate Connection	Initiates a connection to the specified host when any data is received on the
When any data is	serial port.
received	Default: Disabled
Initiate Connection	Initiates a connection to the specified host only when the specified character is
When <hex value>	received on the serial port.
is received	Default: Disabled
Permit	When this option is enabled, the connection can be initiated by either the
Connections in	IOLAN or a host.
Both Directions	Default: Disabled

127