Philips DBS-EX23-530 manual CSU Equipment

Introduction to the ISDN Interface Pre-Installation Requirements

CSU Equipment

The installer must provide a Channel Service Unit (CSU) plus CSU cabling.

The CSU equipment must meet the specifications contained in Table 1-3.See page 2-12for instructions on installing the CSU.

Table 1-3. CSU equipment required for ISDN

Item	Specifications	Vendors
CSU	The Channel Service Unit (CSU) must	The following CSUs have been used suc-
	comply with FCC Part 15 and Part 68. The	cessfully with the DBS ISDN.
	CSU is installed between the DBS and the	Kentrox
	public network. The CSU provides alarm,
		Kentrox T-SERV II 
	diagnostic, and monitoring functions, as
		or
	well as network protection.
		Kentrox T-SMART 
		(Kentrox can be contacted at 1-800-733-
		5511.)
CSU	Each CSU requires a network cable and an equip-	For Kentrox CSUs
Cabling	ment cable. The network cable connects from the	Kentrox offers prefabricated cables for their CSUs.
	CSU to the network interface. The equipment cable
		For the network cable, order part number 01-
	connects from the CSU to the DBS ISDN MDF
		93010151. For the equipment cable, order part
	card.
		number 01-93010121.
	For Kentrox CSUs
		If you fabricate your own cables, use 24 AWG
	The network cable requires a female DB-15 con-	stranded cable that includes shielding for each pair.
		Belden (Richmond, IN) offers stranded cable that
	nector and an RJ48C connector. The equipment
	cable requires a male DB-15 connector and an	complies with these specifications. Order part
	RJ48C connector.	number 8723.
	To simplify installation, you can order the prefabri-
	cated cables shown in the “Vendors” column.
	If you fabricate your own ISDN cables, you should
	use 24 AWG stranded cable that includes shielding
	for each pair. For best results, use the cable listed
	under “Vendors.”
	For Premier CSUs
	You must fabricate your own cables for the Premier
	CSU. The network cable requires two RJ48C con-
	nectors. The equipment cable connects to an RJ48C
	connector on the ISDN MDF card and to four
	screw-down terminals on the CSU.
	For both cables, use 24 AWG stranded cable that
	includes shielding for each pair. For best results,
	use the cable listed under “Vendors.”

Revised April 2000 DBS-EX23-530 1-9