Philips DBS-EX23-530 manual Lpic

Introduction to the ISDN Interface		Pre-Installation Requirements
9	Long distance Carrier (IntraLATA)	This identifies the carrier who will provide
	(LPIC)	access for connections, which are not local
		but are still within the local LATA.
10	Request date of installation
11	Facility type	ISDN PRI
12	Facility quantity	1 or 2 spans
NOTE THAT THE FOLLOWING ITEMS MUST BE PROVIDED ON A PER SPAN BASIS
13	Signaling code	DS-1 (1.544 Mbps)
14	Line coding	B8ZS (Binary 8 Zero Substitution)
15	Framing Format	ESF (Extended Superframe)
16	Bearer configuration	Voice or Voice/Data (see note on page 1-3)
17	Quantity of B (bearer) channels	23B + 1D - Max. setting (must have 1 D
		channel)
		Or XB + 1D where X is 1-23 for a frac-
		tional span
18	Call type	Two Way
19	Quantity of phone numbers	Block of 20 numbers are generally
		assigned. With DID, note that the total
		number of telephone numbers will exceed
		the total number of B channels.
20	Number of incoming digits to CPE (Cus-	Select 4 digits. This is used with DID.
	tomer Premise Equipment – DBS)
21	ISDN PRI Protocol	5ESS Custom or
		DMS-100 Custom (NTNAPRI) or
		4ESS
22	Glare Resolution	CPE yield to CO
23	Channel selection used by CO	High-to-Low B-channel selection
24	Source of Calling Party Number	Calling Party Number must be sourced by
		the CO.
25	Service Options	ANI – Automatic Numbering Indication
		Hunt group -
		MegaCom –only for 4ESS operation

Note: 1- If two spans are implemented, each must have a separate D channel, i.e. D channel sharing is NOT permitted.

Revised April 2000 DBS-EX23-530 1-5