Philips DBS-EX23-530 manual Digital Pad Settings Programming Reference

Digital Pad Settings Programming Reference

Digital Pad Settings

Parameter	Digital Pad Settings
Description	Adjusts the volume of connections made via the ISDN. Default volume
	levels are included for connections between different types of terminals
	or circuits. For example, a K-TEL to ISDN connection may use one vol-
	ume setting, while an SLT-to-ISDN connection may use another.
	The volume settings are controlled by changing a pad number, which in
	turn changes the loss or gain of the connection. In most cases, the default
	pad settings do not need to be changed.
Programming	If the volume level of a connection is unsatisfactory, include the receiving
	and sending circuit types in the command, then adjust the volume by assign-
	ing a new pad number. Figure 4-1shows the numbers used to identify each
	circuit type. Pad numbers are defined in Figure 4-3 on page 4-13.
	FF1 8# 4# 3# (1-12)# (1-12)# (0-30)#
	Receiving	Sending	PAD No.
	Circuit Type	Circuit Type
	(“To” Side)	(“From” Side)
	(Note: This uses the same address as T1 programming.)
	Figure 4-1. Circuit-type numbers
	Circuit Types	No.
	K-TEL	1
	SLT	2
	DATA#	3
	Analog CO Trk	4
	ISDN Master	5
	ISDN Slave	6
	OPTION 1*	7
	OPTION 2*	8
	DTMF#	9
	CONF (SCC)#	10
	TONE1 (MFR1)#	11
	TONE2 (MFR2)#	12

Notes:

#Circuit Types 3 and 9-12 are reserved for future use.

*Options 1 and 2 can be used to assign unique PAD levels to circuits that require special volume levels. For example, if an OPX station needs a higher volume level than other SLTs, the OPX station could be defined as an “Option 1” circuit type.

4-12 DBS-EX23-530 Revised April 2000