Philips DBS-EX23-530 manual Installation Installation Procedures, Parameter System Configuration

Installation Installation Procedures

Figure 2-1. CSU installation

2.Connect the network cable from the network side of the CSU to the network demarcation point. (The network demarcation is typically an RJ48C “smartjack.”)

3.Test the CSU cabling by performing the following steps.

Note: The following procedure can only be used with CSUs that provide a local loopback. When testing the CSU, be sure it is set to “local loopback,” rather than “line loopback.” Line loopback provides a loopback between the CSU and the network.

The CSU can be tested only after the following parameters have been set. For a summary of these parameters, see Chapter 3, “Quick-Start Programming.” The page numbers included in the following table reference detailed descriptions included in Chapter 4.

Parameter	Page No.
System Configuration	4-3

Revised April 2000 DBS-EX23-530 2-13