#99xxxx (where xxxx = the site's private password)
5.After the DBS responds, type P and then press Enter.
6.Follow the directions on the screen to access the desired program. (See “Terminal Programming Commands.”)
Terminal Programming Through DISA
Note: The DBS must be equipped with an MFR card and an RAI card to allow terminal programming using this method.
When programming through a DISA trunk, perform the following steps:
1.Dial into the DBS through a DISA trunk.
2.Once you are connected, type #6 followed by the private password from your terminal communications program.
3.After the DBS responds with REMT>, type P and then press Enter.
4.Follow the directions on the screen to access the desired program. (See “Terminal Programming Commands.”)
Terminal Programming Through a CO Trunk and Operator Transfer
Note: The DBS must be equipped with an MFR card and an RAI card to allow terminal programming using this method.
SPECIAL NOTICE: If you use the following method, the private password must be given to the attendant. Use the new RAI access method instead. (See “Additional RAI Access Method”)
When programming through a normal trunk, perform the following steps:
1.Dial into the DBS through a normal trunk.
2.Ask the operator to place you on hold and dial #6 followed by the private password to transfer you into remote programming.
3.After the DBS responds with REMT>, type P and then press Enter.
4.Follow the directions on the screen to access the desired program. (See “Terminal Programming Commands.”)
DBS Manual - Revised April 2000 | Page |
