Phonetics 1104 user manual Programming Input Configuration, Status

Sensaphone® Model 1104 User’s Manual

For example, if a magnetic reed switch (a normally- closed sensor used to detect unauthorized entry) has been wired to the Model 1104, make sure that the door or window to be monitored is shut before con- figuring the input. If a motion-detector is wired to the unit, it is advisable to block all sources of motion from the sensor before and during configuration.

5.1.1	Programming Input Configuration
	1.	Press STANDBY to place the Model 1104 in Standby
	mode.
		RUN
		STANDBY
	2.	Wire sensors to the inputs to the back of the Model 1104 (see
	Chapter 2, Section 2.10).
	3.	Press RUN. The red light glows when the Model 1104 returns
	to Run mode.
		RUN
		STANDBY
	4.	Press SET.

SET

#

5. Press CONFIGURE.

STATUS

CONFIGURE

6. The Model 1104 audibly recites the configuration for each of

the four inputs:

• If the input is normally open, the Model 1104 recites the

number of the input and says “OK.”

• If the input is normally closed, the Model 1104 recites the

number of the input, followed by a “beep” and “OK.”

• If the input is configured as temperature, the Model 1104

recites the number of the input, followed by “Temperature.”

64