98
Communications / Dial-out:
Problem | Cause | Solution | |
(Continued from previous page) | You did not allow the telephone to ring | When calling the Model 1104, and the TAD is | |
|
| 10 times. Note: If the TAD (telephone answer- | disabled, allow the telephone to ring 10 times. |
3. | The Model 1104 will not answer the | ing device) is disabled, the telephone rings ten | Refer to Chapter 6, Section 6.1.3, and Chapter |
| telephone for Callback | times before the Model 1104 answers. If the | 4, Section 4.6.3. |
| Acknowledgement. | TAD is enabled, the telephone rings once |
|
|
| before the Model 1104 answers the call. |
|
|
|
|
|
4. | The Model 1104 recites the alarm | The local voice mute feature is in effect. | Deactivate local voice mute. |
| message or Status Report over the |
| Refer to the programming steps in Chapter 4, |
| telephone, but is silent at the installation |
| Section 4.9. |
| site. |
|
|
|
|
|
|
5. | The Model 1104 dials out correctly but | Voice Reps is set to zero. | Reprogram Voice Reps to 1 or greater. |
| fails to audibly recite its alarm message |
| Refer to Chapter 4, Section 4.10. |
| when you answer the call. |
|
|
|
|
|
|
6. | The Model 1104 and telephone answering | The Model 1104’s number of Rings Until | Change the number of Rings Until Answer for |
| device (sharing the same line) answer | Answer is set to equal the number of rings set | the Model 1104. |
| incoming calls simultaneously. | for the telephone answering device. | Refer to Chapter 4, Section 4.5. |
|
|
|
|
