1 TouchA.MENU and DSP and then touch
NEXT.
2 TouchSPEAKER LEVEL.
3 Touch or to select the speaker to
beadjusted.
Eachtime you touch or selects the
speakerin the following order:
FRONT-L(front speaker left)CENTER (center
speaker)FRONT-R(front speaker right)
REAR-R(rear speaker right)REAR-L (rear
speakerleft)SUB WOOFER (subwoofer)
#Youcannot select speakers whose size is set
atOFF.
4 Touch or to adjust the speaker
outputlevel.
Eachtime you touch or increases or de-
creasesthe speaker output level. +10 10 is
displayedas the level is increased or de-
creased.
Note
Toadjust the speaker output levels in this mode is
thesame as making the speaker output levels at
TESTTONE. Both provide the same results.
Adjusting the speaker outputlevels using a test tone
Aconvenient test tone allows you to easily get
theoverall balance right among the speakers.
1 TouchA.MENU and DSP and then touch
NEXT.
2 TouchTEST TONE.
3 TouchSTART to start the test tone out-
put.
Thetest tone is outputted. It rotates from
speakerto speaker in the following sequence
atintervals of about two seconds.The current
settingsfor the speaker over which you hear
thetest tone are shown in the display.
FRONT-L(front speaker left)CENTER (center
speaker)FRONT-R(front speaker right)
REAR-R(rear speaker right)REAR-L (rear
speakerleft)SUB WOOFER (subwoofer)
Checkeach speaker output level. If no adjust-
mentsare needed, per form step 5 to stop the
testtone.
#Youcan also start the test tone output by mov-
ingthe joystick up.
#Thesettings do not appear for speakers
whosesize is set OFF.
4 Touch or to adjust the speaker
outputlevel.
Eachtime you touch or increases or de-
creasesthe speaker output level. +10 10 is
displayedas the level is increased or de-
creased.
#Thetest tone rotates to the next speaker af ter
abouttwo seconds from the last operation.
5 TouchSTOP to stop the test tone out-
put.
#Youcan also stop the test tone output by mov-
ingthe joystick down.
Notes
!Ifneeded, select speakers and adjust their ab-
soluteoutputlevels. (Refer to Adjusting the
speakeroutput levels on the previous page.)
!Toadjust the speaker output levels in this
modeis the same as making the speaker out-
putlevels at SPEAKER LEVEL. Both provide
thesame results.
Digital Signal Processor
En 71
Section
14
DigitalSignal Processor