Adjusting initial settings
1
Initialsettings lets you per form initial setup of
differentsettings for this unit.
1Functiondisplay
Showsthe function names.
1 Touchthe source icon and then touch
OFFto turn this unit off.
#Whenthe source icon is not displayed, you
candisplay it by touching the screen.
2 TouchA.MENU and then touch INITIAL
todisplay the function names.
Thefunction names are displayed and oper-
ableones are highlighted.
#WhenA.MENU is not displayed, you can dis-
playit by touching the screen.
#Youcan also display MENU by clicking the
joystick.
#Togo to the next group of function names,
touchNEXT.
#Toreturn to the previous group of function
names,touch PREV.
#Whenthe multi-channel processor (e.g., DEQ-
P7650)is connected to this unit, you can operate
DIGITALATT instead of REAR SPEAKER.
#Toreturn to the previous display, touch BACK.
#Toreturn to the display of each source, touch
ESC.
Setting the FM tuning step
TheFM tuning step employed by seek tuning
canbe switched between 100 kHz, the preset
step,and 50 kHz.
1 TouchA.MENU and INITIAL and then
touchFM STEP.
2 Touchcor dto select the FM tuning
step.
Touchingcor dwill switch the FM tuning
stepbetween 50 kHz and 100 kHz while AF or
TAis on. The selected FM tuning step will ap-
pearin the display.
Note
Ifseek tuning is performed in 50 kHz steps,sta-
tionsmay be tuned in imprecisely. Tune in the sta-
tionswith manual tuning or use seek tuning
again.
Setting the AM tuning step
TheAM tuning step can be switched between
9kHz, the preset step, and 10 kHz. When
usingthe tuner in North, Central or South
America,reset the tuning step from 9 kHz (531
1,602kHz allowable) to 10 kHz (530 1,640
kHzallowable).
1 TouchA.MENU and INITIAL and then
touchAM STEP.
2 Touchcor dto select the AM tuning
step.
Touchingcor dwill switch the AM tuning
stepbetween 9 kHz and 10 kHz. The selected
AMtuning step will appear in the display.
Initial Settings
En
82
Section
16