Switching the warning tone
Ifthe front panel is not detached fromthe
headunit within five seconds of turning off the
ignition,a warning tone will sound. You can
turnoff the warning tone.
1 TouchA.MENU and INITIAL and then
touchDETACH WARNING.
2 Touchato turn warning tone on.
#Toturn warning tone off, touch b.
Switching the auxiliary setting
Itis possible to use auxiliar y equipment with
thisunit. Activate the auxiliar y setting when
usingauxiliary equipment connectedto this
unit.
1 TouchA.MENU and INITIAL and then
touchAUX.
2 Touchato turn auxiliary setting on.
#Toturn auxiliary setting off, touch b.
Setting the rear output andsubwoofer controller
Thisunits rear output (rear speaker leads out-
putand RCA rear output) can be used for full-
rangespeaker (FULL) or subwoofer (SUB. W)
connection.If you switch the rear outputset-
tingto the SUB. W, you can connect a rear
speakerlead directly to a subwoofer without
usingan auxiliary amp.
Initially,the unit is set for rear full-range speak-
erconnection (FULL). When rear output is
connectedto full range speakers (when FULL
isselected), you can connect the RCA sub-
wooferoutput to a subwoofer. In this case, you
canselect whether to use the subwoofer con-
trollers (low pass filter,phase) built-in SUB.W
orthe auxiliary FULL.
!Whenthe multi-channel processor (e.g.,
DEQ-P7650)is connected to this unit, you
cannotoperate this function.
1 TouchA.MENU and INITIAL and then
touchREAR SPEAKER.
2 Touch or to switch the rear out-
putsetting.
Touch toselect full-range speaker and
FULLappears in the display. Touch to select
subwooferand SUB. W appears in the display.
#Whenno subwoofer is connected to the rear
output,select FULL.
#Whena subwoofer is connected to the rear
output,set for subwoofer SUB. W.
#Whenthe rear output setting is SUB. W, you
cannotchange the subwoofer controller.
3 Touch or to switch the subwoofer
outputor non fading output.
Touch toselect subwoofer output and
SUB.Wappears in the display. Touch to se-
lectnon fading output and FULL appears in
thedisplay.
Notes
!Evenif you change this setting, there is no
outputunless you turn the nonfading output
(referto Using nonfading output on page 62)
orsubwoofer output (refer to Using subwoofer
outputon page 62) in the audio menu on.
!Ifyou change the subwoofer controller, sub-
wooferoutput and nonfading output in the
audiomenu return to the factory settings.
!Bothrear speaker leads output and RCA rear
outputare switched simultaneously in this
setting.
Initial Settings
En 83
Section
16

InitialSettings